Subaru IMPREZA WRX/STI INSTRUCTIONS SUPPLIMENTAL
2004 and later WRX/STI's have additional plug-ins sensory connected to a duct intake. When the plug is connected to the factory tube an electrical connection is made, says ECU that PVC flexible hose is attached to the inlet. Hose inlet PERRIN requires skipping the connector. Again this is not "active" sensor. The connector terminates the circuit only. After the inlet hose is installed:
1. remove the grey PVC Diagnostics connector and hose leading to the crankcase ventilation. Crankcase vent is located on a block under the turbo. (see photograph)
2. inside the connector PVC diagnosis find pin jumper and remove it by using the needle nose pliers. This pin is lightly pressed into the electrical connector.
3. find the pipe/plug that was disconnected from the factory inlet hose and place pin jumper, which is removed form the grey connector PVC pipe to female pins/plug-ins. Electrical tape allows you to safely in place.
4. See instructions on the page (3) for the connection and the hose from inlet hose routing PERRIN.
Filename: 2004 Subaru Impreza WRX/STI Turbo inlet hose
Language: English
File : PDF
Size: Mb
You can Download 2004 Subaru Impreza WRX/STI Turbo inlet hose Below
If the information you are looking for less, you can use the sponsored links to get related information
Get the file Download here | PDF-HOME